日韩av高清-岛国一区-寡妇激情做爰呻吟-综合一区二区三区-高清亚洲-久久国产福利-久久精品99国产国产精-艳妇乳肉豪妇荡乳av-制服下的诱惑暮生-国产成人专区-四虎免费影视-干干干操操操-亚洲综合色一区-日韩啪啪网-日日夜夜精-精品国产无码一区二区三区-亚洲永久精品在线观看-亚洲最大福利网站-亚洲色图 美腿丝袜-极品日韩-国模杨依粉嫩蝴蝶150p-日韩成人精品一区-韩国av永久免费-天堂网中文在线观看-久久久久久久久久一区-在线免费黄色av-午夜免费福利在线-亚洲 成人 av-欧洲熟妇牲交-美女被强行插入

In our daily use of lightning surge tester, everyone will encounter the problem that the lightning surge tester is incompatible with the insulation and voltage withstand test. This situation does exist. Many users do not know how to deal with this problem, which not only wastes their own time, but also wastes the test time, Today, Shanghai suoshen electronic editor will tell you about the specific reasons for the incompatibility of lightning surge tester in insulation and withstand voltage test.

A long time ago, a customer asked the editor that the lightning surge tester was incompatible with the insulation withstand voltage test. The lightning surge tester test could pass, but the safety regulation could not pass. If the safety regulation could pass, the lightning surge tester could not pass.

When doing surge test, it is often necessary to add protective devices such as varistors, gas discharge tubes, TVs, etc., but after adding these protections, the voltage withstand test cannot pass. Can you remove these devices when doing insulation voltage withstand test? Is there a method that can pass both surge and voltage withstand test?

This is indeed a problem. In the industrial control computer of the power industry, a lightning protection filter board is added at the power port. The “discharge ground” of the discharge tube is not directly connected with the PG of the three core power line, but through external cables. That is, when doing surge test, connect PG directly with the discharge ground. When doing safety test, disconnect the discharge ground from PG, so at that time, I suggested the customer to make a physical switch to open when testing withstand voltage and close when testing lightning strike.

In response to the customer’s questions, I also checked the relevant information. It is stated in iec60950 safety test that those protective devices should be removed during voltage withstand test.