日韩av高清-岛国一区-寡妇激情做爰呻吟-综合一区二区三区-高清亚洲-久久国产福利-久久精品99国产国产精-艳妇乳肉豪妇荡乳av-制服下的诱惑暮生-国产成人专区-四虎免费影视-干干干操操操-亚洲综合色一区-日韩啪啪网-日日夜夜精-精品国产无码一区二区三区-亚洲永久精品在线观看-亚洲最大福利网站-亚洲色图 美腿丝袜-极品日韩-国模杨依粉嫩蝴蝶150p-日韩成人精品一区-韩国av永久免费-天堂网中文在线观看-久久久久久久久久一区-在线免费黄色av-午夜免费福利在线-亚洲 成人 av-欧洲熟妇牲交-美女被强行插入

Have you achieved the standard operation of the burst generator test

Have you achieved the standard operation of the burst generator test
Everyone must know how to use the pulse group generator, but I want to say that when we use the pulse group generator for the test, we must be standardized, because the operation principle of the pulse group generator is a relatively complex device. If we do not carry out the standard operation in the test, it is likely to cause line errors and test obstacles. So today, I will tell you about the specifications that the pulse group generator should comply with in the test

First of all, we need to know that the pulse group generator test uses interference to charge the line junction capacitance. When the energy on the junction capacitance accumulates to a certain extent, it may cause line (or even system) errors. Therefore, there is a process of line error, and there is a certain contingency. It cannot be guaranteed that the error will occur at any interval, especially when the test voltage is close to the critical value. For this reason, some product standards stipulate that the test on the power line is conducted between the line and the ground. It is required to conduct three tests on one line under one test voltage polarity, one minute each time, with an interval of one minute: after one polarity is completed, change to another polarity. When one line is finished, change to another line. Of course, pulses can also be injected into two lines, or even several lines at the same time.